Galls Street Thunder ST280 Kurulum ve Kullanım Talimatları Kılavuzu - Sayfa 8
Amplifikatör Galls Street Thunder ST280 için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Talimatları Kılavuzu indirin. Galls Street Thunder ST280 18 sayfaları. Siren amplifier & light controller
Ayrıca Galls Street Thunder ST280 için: Kurulum ve Kullanım Talimatları Kılavuzu (20 sayfalar)
Sayfayı Yazdır
Siren Wiring Connections
Optional Connections:
BLUE: (Pins 3 & 6) Input From Radio - Used for radio repeat. Connect
one blue lead to each terminal of the radio speaker or output
connector of the radio. Most radio outputs are isolated, in which
case polarity would not be important. Radios with polarity
sensitive outputs should be connected w/ the blue wire from pin 6
to the positive radio output, and the blue wire from pin 3 to the
negative radio output. Use #18 AWG wire.
GREEN: (Pin 10) AUX or Horn Ring - Used for remote Manual (or Air
Horn) control. Connect to the horn ring circuit or some other
remote switch. Circuit may be positive or negative with proper
jumper selection. See INSTALLER-SELECTABLE OPTION
section (page 3 and 4) for jumper details.
NOTE: Cut lead short if not used & insulate w/ electrical tape.
GRAY: (Pin 8) Park Kill (Cut-off) – This wire is used to de-activate the
siren when the vehicle is exited. Connect to dome light or added
door switch. Circuit may be positive or negative with proper
jumper selection. See INSTALLER-SELECTABLE OPTION
section (page 4) for jumper details.
NOTE: Be sure to cut lead short if not used and insulate with
electrical tape.
Testing -
Test all siren functions after installation to assure proper
operation. Test vehicle operation to assure no damage to vehicle.
:
(CONTD)
-7-