AGS Parksafe Control Panel Kurulum, Çalıştırma ve Bakım Kılavuzu - Sayfa 8
Kontrolör AGS Parksafe Control Panel için çevrimiçi göz atın veya pdf Kurulum, Çalıştırma ve Bakım Kılavuzu indirin. AGS Parksafe Control Panel 20 sayfaları. Ventilation control panel
Ayrıca AGS Parksafe Control Panel için: Kurulum ve Kullanım Kılavuzu (16 sayfalar), Kurulum ve Kullanım Kılavuzu (16 sayfalar), Kurulum Operasyon ve Bakım (16 sayfalar)
Sayfayı Yazdır
Installation, Operation & Maintenance
Power and Modbus data are wired between detectors with the first connected to a ParkSafe controller
[Detector Chain] terminal. If using a shielded wire (recommended) then connect the shield to [Shield Wire]
dedicated terminals.
Up to sixteen (16) ParkSafe detectors can be connected, chained in a parallel 'daisy chain' method up to
approx. 545 yards from the controller depending on chain configuration, wire type and condition. Any other
way may cause issues or damage to the overall system.
It is recommended that the cable of same color should be used to connect all [D+] terminals together and
similarly cable of same color is used to connect all [D-] terminals together.
Single chain example.
Split chain example
Rev: 20
For Modbus communications, a shielded cable is used.
The shielding can be of 2 types: braided [mesh of thin conducting wires] or
foil (consisting of a thin sheet of metal covering the twisted wires).
One example of such cable is BELDEN 3082A.
ParkSafe Controller
8