HIKE CREW HICPSBT Kullanıcı Kılavuzu - Sayfa 10

Su Isıtıcı HIKE CREW HICPSBT için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. HIKE CREW HICPSBT 15 sayfaları.

STORING YOUR PORTABLE WATER HEATER

1. Press the Power Button to ensure the device is switched off.

2. Disconnect all hoses and hold them vertically to allow all excess water

to drain from them. Check that the flow regulator switch on the shower

head is in the "on" position.

3. Unscrew the regulator assembly from the device and remove the

propane tank.

4. Tip the appliance towards the back to drain excess water from the heat

exchanged through the water inlet.

5. Repack the unit into the carrying case for safer storage.

POWER AND CHARGING

The charging system is designed to allow the battery to recharge while the

device is in operation. Charging time will increase by 50% if the device is in

operation while charging.

To charge the 12 V 3.2 A/hr battery, use the AC/DC power adapter

(attachment #4). The 12 V DC cigarette lighter adapter (attachment #5)

will power the unit, but will not charge the battery.

1. Switch on the device so that the battery charge level illuminates to recharge

the appliance from either an AC or DC power source (attachment #4).

2. Connect to the Main DC power input (connection point #4) on the back

of the device. The battery charge level will start to flash and move from red

to green to indicate that the battery is charging.

Note: When the battery is fully charged, the battery charge level light will

stop flashing.

3. Connect the three (3) pin plug to an appropriate outlet and

connect the plug to the device.