Adesso 5100 Manuel - Sayfa 11

Barkod okuyucu Adesso 5100 için çevrimiçi göz atın veya pdf Manuel indirin. Adesso 5100 19 sayfaları.

Aimer setting

*Aimer Enable

Enable

Lighting configuration*Light Enable

Test Mode

After you configure a test mode, the device is automatically triggered every second decoding again.

Device is configured to blink test mode

Barcode length locking configuration

It supports up to six kinds of bar code type length locks

Add a single bar code type length locking configuration process:

Example 1, the locking QR code length is 32, QR barcode types byte values by type of bar code lookup table to

obtain 108.

1. Scan "to enter / exit the programming mode" to make the device into programming mode.

2. Scan "Configuring bar code type 1 length."

3. Successively scan bytecode value "0", "3", "2."

4. Scan "Configuring bar code type 1 byte values."

5. Bytecode sequentially scan the value "1", "0", "8."

6. Scan "to enter / exit the programming mode."

Add more length locking bar code type:

Example 3

1. Scan "to enter / exit the programming mode" to make the device into programming mode.

2. Scan "Configuring bar code type 1 length."

3. Successively sweep byte code value.

4. Scan "Configuring bar code type 1 byte values."

5. Successively sweep byte code value.

6. Scan "Configuring bar code type 2 length."

7. Successively sweep byte code value.

8. Scan"Configuring bar code type 2-byte value."

Enable

*Cancel the test mode is configured to blink

Aimer prohibit

prohibit

Light prohibit

prohibit

11 / 18