Adesso 5100 매뉴얼 - 페이지 11
{카테고리_이름} Adesso 5100에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Adesso 5100 19 페이지.
Aimer setting
*Aimer Enable
Enable
Enable
Enable
Lighting configuration*Light Enable
Test Mode
After you configure a test mode, the device is automatically triggered every second decoding again.
Device is configured to blink test mode
Barcode length locking configuration
It supports up to six kinds of bar code type length locks
Add a single bar code type length locking configuration process:
Example 1, the locking QR code length is 32, QR barcode types byte values by type of bar code lookup table to
obtain 108.
1. Scan "to enter / exit the programming mode" to make the device into programming mode.
2. Scan "Configuring bar code type 1 length."
3. Successively scan bytecode value "0", "3", "2."
4. Scan "Configuring bar code type 1 byte values."
5. Bytecode sequentially scan the value "1", "0", "8."
6. Scan "to enter / exit the programming mode."
Add more length locking bar code type:
Example 3
1. Scan "to enter / exit the programming mode" to make the device into programming mode.
2. Scan "Configuring bar code type 1 length."
3. Successively sweep byte code value.
4. Scan "Configuring bar code type 1 byte values."
5. Successively sweep byte code value.
6. Scan "Configuring bar code type 2 length."
7. Successively sweep byte code value.
8. Scan"Configuring bar code type 2-byte value."
Enable
Enable
Enable
*Cancel the test mode is configured to blink
Aimer prohibit
prohibit
prohibit
prohibit
Light prohibit
prohibit
prohibit
prohibit
11 / 18