AGS Parksafe Control Panel Kurulum Operasyon ve Bakım - Sayfa 5

Kontrol Paneli AGS Parksafe Control Panel için çevrimiçi göz atın veya pdf Kurulum Operasyon ve Bakım indirin. AGS Parksafe Control Panel 16 sayfaları. Ventilation control panel
Ayrıca AGS Parksafe Control Panel için: Kurulum ve Kullanım Kılavuzu (16 sayfalar), Kurulum ve Kullanım Kılavuzu (16 sayfalar), Kurulum, Çalıştırma ve Bakım Kılavuzu (20 sayfalar)

Installation, Operation & Maintenance

Access & Mounting

Unpack all the parts!

Designed for surface mounting, it must be installed by a licensed,

insured contractor.

Carefully remove the front cover from the unit by unscrewing the

four bolts located at each corner. To do this – use the socket

wrench provided.

Mark the four screw holes located on the back of the enclosure to

the wall. Ensure the wall surface is flat to prevent base distortion.

After executing the mounting and the connections – replace the

front cover and insert the security caps over the four bolts.

Be careful when creating access for cables – Damage to circuit boards will void any warranty!

Any damage attempting to remove the circuit board parts may void any warranty!

Detectors must be earthed/grounded for electrical safety and to limit the effects of EMC or R/F interference!

For MODBUS communications, a shielded cable is used!

Do not remove the Gas Sensor Module when the system is powered!

Rev: 13

0721

Parksafe Control Panel