Maimiao MX5 Kullanıcı Kılavuzu - Sayfa 2

Güvenlik Kamerası Maimiao MX5 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Maimiao MX5 5 sayfaları. Smart light

Sayfayı Yazdır
Product Installation Instruction
1.Hold the side of Wall Mouting Plate by hand, slightly rock up and down,
then pull out the Wall Mouting Plate
D
C
B
C
A
2.First made the power cable via to the F hole> connect the cable to green
power socket (E position)> use screwdriver to fix the cable
the installation environment>select one installation mode (A to D) to fix the Wall
Mouting Plate on the wall.
A. (For no Outlet):Mark 4 A position points with a pen>Drill holes above marked points>Tap in 4 plastic
plugs> Lock 4 screws to fix the Wall Mouting Plate on the wall.
B. (For Square Outlet):Use 2 M4 screw to aim the outlet screw hole >lock the screw to fix the Wall
Mouting Plate and square Outlet .
C. (For Rectangle Outlet):Use 2 M4 screw to aim then outlet screw hole> lock the screw to fix the Wall
Mouting Plate and Rectangle Outlet .
D.(For Circular Outlet): First lock 2 long M4 screws on the circular bracket >use two short M4 screws fix
the circular bracket to outlet>place the Cover Pad on the bracket >Insert 2 bracket screws after aligning the
Plate holes > lock the nut to finish Wall Mouting Plate fixed to the circular bracket.
A
A
A.Screw hole
B.Square outlet fixing screw
hole
C.Rectangleoutlet fixing
B
screw hole
D.Round bracket nut fixing
G
hole
D
LAN
E.Green Power socket
E
F
G.LAN Socket(Option)
A
tight>according to
3. Align the Housing back Rectangle gap
with the Wall Mouting Plate
> press the Housing close to the Plate
>lock the up & bottom lock screws to
complete the installation.
Recommend installation height is 2.5M:
Distance from the ground to the bottom of
the product.
2
Top Lock Screw
M4 Screw
M4 Screw
Bottom Lock Screw Hole
Cover Pad
For Circular
Outlet (option): as shown in the
figure above
first lock two long M4 screws on the circular
bracket.
>use 2 short M4 screws to fix the bracket on the
outlet.
> place Cover Pad between bracket and plate
>insert two screws into the screw holes of the
plate.
>lock two spare nuts at D position to fix the plate
& circular bracket.