Deagostini Model Space HUMMER H1 Manuel - Sayfa 14

Oyuncak Deagostini Model Space HUMMER H1 için çevrimiçi göz atın veya pdf Manuel indirin. Deagostini Model Space HUMMER H1 18 sayfaları.

HUMMER H1: STEP BY STEP

Place the first 3 × 3mm

set screw (Stage 46)

onto the tip of the

1.5mm Allen key. Apply

a little thread-locking

agent (or rubber-based

adhesive), then begin

to tighten into the hole

in the side of the 2mm

stopper (also Stage 46).

Secure the stopper in

place by tightening

the set screw with the

Allen key.

Slide one of the lengths

of silicon tubing over the

free end of the throttle

linkage rod.

Slide the 2mm stopper

over the free end of the

throttle linkage rod.

Turn the set screw

into the hole, but stop

before it enters the

central hole. Leave the

Allen key in place.

Use the cutters to remove

the curved tip at the right

side of the servo horn.

Follow the dotted line

shown in this photo, and

use the photo of Step 38

as a reference. Do not

try to cut the tip off all at

once, but instead go little

by little.

218

Slide the tube along until

it rest against the side of

the linkage base.

Push the 2mm stopper

along the rod until it rests

against the silicon tubing

fitted in Step 17.

™