HIKVISION D8T Series Kullanıcı Kılavuzu - Sayfa 9

Güvenlik Kamerası HIKVISION D8T Series için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. HIKVISION D8T Series 17 sayfaları. Turbo hd turret camera
Ayrıca HIKVISION D8T Series için: Kullanıcı Kılavuzu (17 sayfalar), Kullanıcı Kılavuzu (17 sayfalar), Kullanıcı Kılavuzu (17 sayfalar), Kullanıcı Kılavuzu (12 sayfalar), Kullanıcı Kılavuzu (16 sayfalar), Kullanıcı Kılavuzu (15 sayfalar), Kullanıcı Kılavuzu (12 sayfalar)

1). Hold the camera body and rotate the enclosure

to adjust the pan position [0° to 360°].

2). Move the camera body up and down to adjust

the tilt position [0° to 75°].

3). Rotate the camera body to adjust the rotation

position [0° to 360°].

2.3 Ceiling Mounting of Type III Camera

Steps:

1. Paste the dill template to the ceiling.

2. Drill the screw holes and cable hole (optional) in the

ceiling according to the drill template.

Note:

Cable hole is required, when adopting the ceiling

outlet to route cables.

3. Loosen the set screws with a hex wrench (supplied)

to remove the bubble.

4. Fix the mounting base on the ceiling with supplied

screws.

Figure 2-13 Fix the Mounting Base

5. Route the cables through the cable hole, or the side

opening.

6. Connect the corresponding cables, such as power

cord, and network cable.

7. Power on the camera to check whether the image

on the monitor is gotten from the optimum angle. If

not, adjust the camera according to the figure below

to get an optimum angle

Hole A: for cables routed through the ceiling

screw hole 1: for Mounting Base

Figure 2-11 Drill Template

Figure 2-12 Remove the Bubble