Adexa ZBS Series Kullanım Kılavuzu - Sayfa 5

Buz Yapıcı Adexa ZBS Series için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Adexa ZBS Series 5 sayfaları. Commercial flake ice maker

Sayfayı Yazdır
Structure:
Item
Description
Operation Panel
1
Front Panel
2
Door
3
Screw of Drainage
4
Ice Lever Sensor
5
Ice Storage Container
6
D I S P L A Y B O A R D
RUN
FAULT ICE FULL WATER LOW
DISPLAY BOARD
Indicator
I nstruction
Connect the power for a short time;
No indicator is on
In trouble self-correct state
Running i ndicator
Ice flaker is Normal
is o n.
Ice full indicator
Ice storage container is full or the
is on.
temperature is below 5℃.
Water shortage
No water into the cabinet. But once there
indicator is
is water, it will operate automatically.
twinkling every
one second.
Water shortage
No water into the cabinet. Reset the
indicator is on.
machine when the water source is recovered
4
1
2
3
4
5
6
7
8
9
10
Item
Description
Power Cord
7
Water inlet
8
Drainage Tube
9
Bottom Foot
10

Operation Procedures:

1.Unpack the package and take out the attached documents and spare
parts such as the water inlet and outlet tubes, ice shovel and gaskets,
etc.
2.Position the ice
f laker
on a well ventilated place and leave at least
150mm room between the ice maker and the wall. Be sure the ice
f laker
is positioned levelly and away from the heat source.
3.Make one end of the φ14 flexible plastic corrugated pipe (supplied
with the machine) connected with the water outlet tube on back of
machine, another pipe end should be placed in a container for
surplus water (prepared by user himself) or in the sewer.
4.Make one end of the water inlet tube (supplied with the machine)
connected with the 3/4" screw type connector of the water tap so
as to get the drinkable tap water. The water pressure of water supply
2
pipe is 1~8 Kg/cm . The other end of the water inlet tube should be
connected with the screw type connector of water valve on the back
of the ice maker. Be sure to put gaskets (supplied with the machine)
in both ends of the water inlet tube before connecting. If it is an ice
for purified water, a φ14 corrugated pipe (supplied with the
f laker
machine) should be used. Connect one end of the pipe with the
purified water supplier (cold water tap or end of water drainage
tube of water dispenser) and another end with water valve
connector on the back of the ice maker. Make sure that the purified
water outlet position is higher than the top of the ice make.
5.Make power connection and press the switch on the panel,the run
indicator light on.Then the maker begins to work. All the procedures:
water inlet ~ ice making ~ice dropping ~ ice storing, are controlled
automatically for ice making continuously. If ice is full in the ice
5