Centrica Modbus TCP Programcı El Kitabı - Sayfa 12

Ağ Donanımı Centrica Modbus TCP için çevrimiçi göz atın veya pdf Programcı El Kitabı indirin. Centrica Modbus TCP 14 sayfaları.

Assign sensors to slots

Any sensor to be used by the Modbus interface must first be allocated to specific location (slot)

within the bridge. Once allocated, this sensor readings are guaranteed to always be in a fixed

Readings from sensors that were not assigned to a slot, will not be provided via the Modbus

interface (but will continue to be sent to PowerRadar if 'Connect to PowerRadar' is set in the

connection configuration page).

Assign a sensor to a slot

1. Navigate to the 'Sensors' tab

2. Choose an empty slot and press the '+' icon

3. In the popup dialog:

a. Type the sensor serial number

b. Type the calibration key if you have it or click 'Get calibration key' to have it

automatically retrieved and inserted.

4. The sensor is now assigned to the slot. New readings will be shown in this screen and

made available via the Modbus TCP interface.

Figure 7 The Sensors Tab

Figure 8 Add Sensor Pop-up