Decagon Devices EM50G Hızlı Başlangıç Kılavuzu
Veri Kaydediciler Decagon Devices EM50G için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Decagon Devices EM50G 2 sayfaları. Using with a user supplied sim
Ayrıca Decagon Devices EM50G için: Manuel (4 sayfalar), Hızlı Başlangıç Kılavuzu (2 sayfalar), Hızlı Başlangıç (2 sayfalar)
Sayfayı Yazdır
1. Launch DataTrac 3.
2. Click the "setup" menu from the toolbar, then "Create New",
then "Em50G Subscription".
3. You will be asked for the Device ID and password for each
Em50G data logger that you subscribe to. Enter the Device ID
and password exactly as they appear on your brightly colored
card that came inside of your data logger. Both the ID and
password are case sensitive.
4. Pick the appropriate server where your data are stored.
Unless Decagon has told you otherwise, your data are being
stored on the "ech2odata.com" server.
5. Click "Subscribe".
6. If you have already subscribed to an Em50G data logger, you
will not need to re-subscribe to download the data from the server.
Downloading Data Subsequent Times
1. Launch Datatrac 3.
2. The most recent data from all of your subscribed Em50G
data loggers will be downloaded automatically.
If you have any questions about configuring your Em50G or
downloading data from the Decagon server, please contact
Decagon at: 1-800-755-2751 or [email protected].
13973-03
2365 NE Hopkins Court
Pullman, Washington 99163
tel: 509-332-2756
Em50G
QuickStart Guide
Introduction
Thank you for purchasing an Em50G data logger. The Em50G is
a data collection device that will allow you to collect and store
data from up to five Decagon sensors. Collected data are sent to
the Decagon Data Service using cellular/mobile communication
up to six times a day. You can access your data from the Decagon
Data Service at any time with DataTrac 3 or Em50G Downloader.
The Em50G is configured using ECH2O Utility or DataTrac 3.
DataTrac 3 is the preferred software package for the Em50G and
will be the primary reference throughout this quickstart guide. To
utilize ECH2O Utility or the Em50G Downloader, please consult
the Em50G user manual.
Em50G Logger Configuration
Please download the most up to date version of DataTrac 3 soft-
ware package from the Decagon website (www.decagon.com)
BEFORE you try to configure your Em50G.
1. Take the brightly colored card containing your Device ID and
put it in a safe place. You will need this number and password to
download your data from the Decagon Data Service.
2. To configure the Em50G, directly connect to the Em50G
logger using the included USB cable and launch DataTrac 3.
3. Select "connect". If you are connected to the internet, you'll
be asked to supply your device ID and password.
4. Select "configure".
5. Choose the sensor plugged into each port
6. Pick your measurement interval. Available measurement
intervals are from five minutes to one day.
7. Click "Apply".
]