GREEN BANK WG48350 Kullanıcı Kılavuzu - Sayfa 5

Pil Paketi GREEN BANK WG48350 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. GREEN BANK WG48350 7 sayfaları. Battery system for households

Sayfayı Yazdır

LiFePO4 Battery System for Households

3. INSTALLATION

3.1 Unpacking and Inspection

Before installation, please inspect the unit. Be sure that nothing inside the package is damaged. You

should have received the following items inside of package.

NAME

SPECIFICATION

Grid activation communication wire

Communication line 1

( used with 6)

Used for Communication among batteries

Communication line 2

Used for communication between battery

Communication line 3

and host computer

Used for battery parallel connection

Cables

Used for activating the pack when grid

Adapter

power recover

Used for auto restart when PV comeback

PV Wake up line

in off-grid system

User manual

Guarantee card

3.2 Mounting the Unit

Consider the following points before selecting where to install:

• Do not mount the battery on ﬂammable construction materials.

• The ambient temperature should be between 0°C and 45°C to ensure optimal operation.

• The recommended installation position is to be adhered to the wall vertically.

• Be sure to keep other objects and surfaces as shown in the right diagram to guarantee sufﬁcient heat dissipation and

to have enough space for removing wires.

Please follow below steps to implement battery connection:

1.Assemble battery ring terminal based on recommended battery cable and terminal size.

2.Connect all battery packs as units requires. It's suggested to connect at least 2 sets of WG48350 for

inverter larger than 6KVA in parallel connection.

Note: if you need the battery wake-up when the grid back, connect the battery with grid use

power adapter and communication line 1 shown in the package list.

3.3 Connection for Parallel Mode

The WG48350 series battery support to be connected in parallel for expansion. If you need one more battery

bank work in parallel mode, connect the battery as shown in PIC 1.

PICTURE

Main Circuit

Step 1: The schematic diagram of the parallel connection of three battery packs is shown in Figure 1.

Note:After completing the above steps, arbitrarily select the positive and negative poles of one of the battery packs to output.

After confirming the correct connection of the inverter, controller and battery, you can turn on any of the switches and

use the battery group happily.

For pure off grid system ,the PV awake wire need to be connected with MPPT charge controller if the battery

pack is charged by solar panels only . The connection diagram as below :

LiFePO4 Battery System for Households