Jalousie-Welt Pergola PRO İşletme ve Bakım, Sevkiyat Talimatları, Ambalajdan Çıkarma ve Kurulum - Sayfa 19
Aksesuarlar Jalousie-Welt Pergola PRO için çevrimiçi göz atın veya pdf İşletme ve Bakım, Sevkiyat Talimatları, Ambalajdan Çıkarma ve Kurulum indirin. Jalousie-Welt Pergola PRO 20 sayfaları.
Sayfayı Yazdır3.8.9. Couple of handle (only manual drive)
Awnings handle into the loop of the gearbox. By turning the handle can open or close the awning.
Awning fabrics must be roll up on the right side (from top) otherwise it can damage the sheathing and
the awning.
3.8.10. Check the awning after installation
After installation, check items from the list below:
Operation (manual or electric).
Stability.
Proper operation of limit switches.
3.8.11. Training and instruction of the enduser before awning in use
Installation team must fully inform the end user about safe use of the awnings.
3.8.12. Handing over all the necessary instructions and warranty the enduser and pass the awning
for use
After assembly, the person in charge of the installation team must sign The handing over protocol/Waranty.
According to knowledge of local conditions and after completion of the assembly, installation team declares
the user whether the manufacturer's wind class was achieved. If not, the installation company must to
document the actual achieved wind class rating.
The handing over protocol/Waranty must be countersigned by the user and installation team.
After assembly the following instructions must be passed to enduser:
Installation manual,
Service and maintenance manuals and warranty (with wind class of the awning),
Settings (only for motor drive),
Sun and wind automatic instruction (only for awning with automatic),
Remote Control Guide (only remote controled awnings),
Handing over protocol/Waranty.
3.9.
Repair the awning
Repairs should be carried out only by a specialist. Only spare parts from DRAGON.
can be used.
3.9.1. Replacement a drive
In order to make a repair to a defective drive, the awning must be using a belt secured. All the necessary
work can be made only by a specialist. The drive must be the same series and by the same manufacturer
are.
3.9.2. Replacement of the sheathing
For this action must be the awning removed. The change must be made by an authorized dealer or the
awning must be sent to the manufacturer to replace the sheathing.
3.9.3. Replacement of the components
The change must be made by an authorized dealer or the awning will be sent to the manufacturer to replace
the item.
page: 19 / 20