IKEA IX5HHEXWS04 Kullanıcı Talimatları - Sayfa 8
Buzdolabı IKEA IX5HHEXWS04 için çevrimiçi göz atın veya pdf Kullanıcı Talimatları indirin. IKEA IX5HHEXWS04 40 sayfaları. Whirlpool
Sayfayı Yazdır
Ad
sf the
Your refrigerator has two adjustable rollers located at the base of
the refrigerator. If your refrigerator seems unsteady or you want
the door to close more easily, use the instructions below.
1. Remove the base grille. Grasp the grille firmly and pull it
toward you.
2,
Using a 3/8"hex driver, turn the roller adjustment screw on
each side to raise or lower that side of the refrigerator.
NOTE: Having someone push against the top of the
refrigerator takes some weight off the adjustment screws and
rollers. This makes it easier to turn the screws. It may take
several turns of the roller adjustment screw to adjust the tilt of
the refrigerator.
•
To raise, turn the roller adjustment screw to the right.
•
To lower, turn the roller adjustment screw to the left.
Turn the brake foot clockwise until it is firmly against the floor
to keep the refrigerator from rolling forward when the freezer
drawer is pulled open.
A
3,
B
A. Front roller adjustment
screw
B. Brake foot
Open the door again to make sure that it closes as easily as
you like. If not, tilt the refrigerator slightly more to the rear by
turning both leveling screws clockwise. It may take several
more turns, and you should turn both screws the same
amount.
4. Replace the base grille.
REFRIGERATOR USE
(Fu:_}nch dool modes}
There are two refrigerator compartment
doors. The doors can be
opened and closed either separately or together.
There is a vertically-hinged
seal on the left refrigerator door.
•
When the left side door is opened, the hinged seal
automatically folds inward so that it is out of the way.
•
When both doors are closed, the hinged seal automatically
forms a seal between the two doors.
A
A. Hinged seal
The temperature controls are located at the top front of the
refrigerator compartments.
Temperature
Controls
For your convenience, the temperature controls are preset at the
factory. When you first install your refrigerator, make sure the
controls are still set to the recommended
setting as shown.
Recommended
Setting "4"
IM PORTANT:
The recommended
setting should be correct for normal
household refrigerator use. The controls are set correctly
when milk or juice is as cold as you like and when ice cream is
firm.
Wait 24 hours for your refrigerator to cool completely before
adding food. If you add food before the refrigerator has cooled
completely, your food may spoil.
NOTE: Adjusting the refrigerator and freezer temperature
controls to a colder than recommended
setting will not cool
the compartments
any faster.
If the temperature is too warm or too cold in the refrigerator or
freezer, first check the air vents to be sure they are not
blocked before adjusting the controls.
To Turn Off/On:
Press the freezer down arrow touch pad until a dash (-) appears in
both the refrigerator and freezer displays. Neither compartment
will cool.
Humidity Control (on some models)
The humidity control turns on a heater to help reduce moisture on
the door hinge seal. Use in humid environments or when you
notice moisture on the door hinge seal. The refrigerator uses more
energy when Humidity Control is on.
•
Press the control to ON when the environment is warm and
more humid, or if you notice moisture on the door hinge seal.
•
Press the control to OFF to save energy when the environment
is less humid.
Humidity Control
On
Off
8