Green Gorilla GG01 Kullanıcı El Kitabı - Sayfa 2

Boya Püskürtücü Green Gorilla GG01 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Green Gorilla GG01 2 sayfaları. Power spray system

Sayfayı Yazdır

HOW TO PREPARE YOUR SPRAYER FOR USE

Charge Your Power Pack

1A) Locate the power connector port on the side of the Green Gorilla

Power Pack.

1B) Connect the charger adapter cable to the power connector port on the

Power Pack.

NOTE: Never charge the power pack while connected to the tank.

Do Not charge outdoors in direct sunlight or if raining or damp.

1C) Plug the power cord into an electrical outlet. (Electrical outlets vary by

region and country.)

1D) Charger indicator light will show green for fully charged and red while

charging. (Approximate charge time for a fully discharged unit is 3

hours.)

Connect Your Power Pack to the Tank

2A) Align the stem (denoted by red dot) on the Power Pack to

the slot in the quick connect tank fitting. (Figure 2A)

2B) Begin inserting power pack into quick connect fitting. There

will be some resistance as you engage the fitting. (Figure 2B)

2C) Push in firmly and rotate the power pack clockwise (Figure 2C)

2D) When firmly seated, the power pack will rest in the upright

position with the stem resting in the J-Slot. (Figure 2D)

Reverse steps 2A thorough 2D to remove Power Pack from spray tank.

Figure 2A

Figure 2B

Assemble extension rod to valve by inserting and

holding rod into open end of valve. Attach extension

cap securely by hand.

NOTE: Never use tools to tighten connection nuts.

Charger Indicator Light

Red = Charging

Green = Fully Charged

™

Figure 1A

Figure 2C

Figure 2D

Figure 3A

HOW TO PREPARE YOUR SPRAYER FOR USE

Remove pump and cap assembly. Mix spray solution in separate receptacle, following directions on

spray solution container.

Strain solution through fine cheesecloth or household strainer to remove particles that could clog

nozzle. Use any amount of liquid up to the "1 Gallon" mark. DO NOT fill beyond this line.

Replace pump and cap assembly and tighten securely. If sprayer has been stored, manually operate

the quick connect valve by pushing in and out on the center red pin several times.

Pressurize tank by switching on the Power Pack. The Power Pack will automatically determine and

maintain the correct tank pressure and will turn on and off accordingly. NOTE: Initial pressurization

could take 1 to 3 minutes.

Alternatively, the sprayer may be pressurized manually with or without the Power Pack attached.

Manually pressurize the tank by pumping approximately 10-20 times (depending upon amount of

liquid used).

PRESSURE RELIEF SYSTEM

The Green Gorilla

™

Spray System is equipped with a built in pressure

relief valve (Figure B). The pressure relief valve will function with or

without the power pack attached to the tank. The pressure relief valve

is part of the patented quick disconnect system and will prevent the

tank from becoming overpressurized. If a hissing sound through the

pressure relief valve is detected, the sprayer is overpressurized. The

pressure relief will reset automatically when the tank pressure is re-

turned to operating limits. The tank may become overpressurized by

manually overpumping or by increased pressure due to heating of the

tank contents from environmental conditions. NOTE: For proper

operation keep pressure relief valve clean of dirt and debris.

HOW TO USE YOUR SPRAYER

Adjust nozzle cap. Tighten cap for fine spray or loosen for coarser spray or

solid stream, see Figure C.

WARNING: Loosening cap too far will result in cap flying off, allowing

spray material to spray back at you.

Check that the Power Pack is attached and in the locked position, (Figure 2D). Turn on the Power

Pack and allow the tank to pressurize. The initial pump time will take approximately 1 to 3 minutes de-

pending upon the amount of liquid used. Once pressurized the Power Pack will automatically maintain

tank pressures and turn on and off accordingly. See figure A for power on/off switch location.

The extension rod can be rotated 360°, turning counter-clockwise with extension rod pointed away from

you.

Store the extension rod by attaching to handle and pushing it into the clip located on the pump handle.

Sprayer should only be carried by top of handle or strap (optional). Never carry tank by the hose or dis-

charge rod.

Figure B

Figure C