HIKVISION TURBO HD U7T Series Kullanıcı Kılavuzu - Sayfa 9
Güvenlik Kamerası HIKVISION TURBO HD U7T Series için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. HIKVISION TURBO HD U7T Series 15 sayfaları. Turret & dome camera
Ayrıca HIKVISION TURBO HD U7T Series için: Kullanıcı Kılavuzu (15 sayfalar), Kullanıcı Kılavuzu (15 sayfalar)
Sayfayı Yazdır
2.3 Ceiling Mounting of Type III Camera
Steps:
1. Paste the dill template to the ceiling.
2. Drill the screw holes and cable hole (optional) in the
ceiling according to the drill template.
Note:
Cable hole is required, when adopting the ceiling
outlet to route cables.
3. Loosen the screws with a hex wrench (supplied) to
remove the bubble.
4. Install the mounting base to the ceiling with supplied
screws.
5. Route the cables through the cable hole, or the side
opening.
6. Connect the corresponding cables.
7. Power on the camera to check whether the image on
the monitor is gotten from the optimum angle. If not,
adjust the camera according to the figure below to get
an optimum angle.
0° to 75°
Figure 2-14 Type III Camera 3-Axis Adjustment
Figure 2-11 Drill Template
Figure 2-12 Remove the Bubble
Figure 2-13 Install the Mounting Base
0° to 355°
Adjusting Screw
0° to 355°