HIKVISION TURBO HD U7T Series Посібник користувача - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник користувача для Камера спостереження HIKVISION TURBO HD U7T Series. HIKVISION TURBO HD U7T Series 15 сторінок. Turret & dome camera
Також для HIKVISION TURBO HD U7T Series: Посібник користувача (15 сторінок), Посібник користувача (15 сторінок)
Друкувати сторінку
2.3 Ceiling Mounting of Type III Camera
Steps:
1. Paste the dill template to the ceiling.
2. Drill the screw holes and cable hole (optional) in the
ceiling according to the drill template.
Note:
Cable hole is required, when adopting the ceiling
outlet to route cables.
3. Loosen the screws with a hex wrench (supplied) to
remove the bubble.
4. Install the mounting base to the ceiling with supplied
screws.
5. Route the cables through the cable hole, or the side
opening.
6. Connect the corresponding cables.
7. Power on the camera to check whether the image on
the monitor is gotten from the optimum angle. If not,
adjust the camera according to the figure below to get
an optimum angle.
0° to 75°
Figure 2-14 Type III Camera 3-Axis Adjustment
Figure 2-11 Drill Template
Figure 2-12 Remove the Bubble
Figure 2-13 Install the Mounting Base
0° to 355°
Adjusting Screw
0° to 355°