Avantco 447APST60 Kullanıcı Kılavuzu - Sayfa 3
Ticari Gıda Ekipmanları Avantco 447APST60 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Avantco 447APST60 8 sayfaları. Commercial sandwich prep tables
Ayrıca Avantco 447APST60 için: Kullanıcı Kılavuzu (7 sayfalar)
Sayfayı Yazdır
Installation
Please read this manual thoroughly prior to equipment setup, operation, and maintenance.
This unit is intended for use in a temperature-controlled environment less than 75°F and 60%
relative humidity. Malfunction due to improper conditions is not covered under warranty.
Important! Please Read Before Installation
• If the shelf has a raised lip, the lip needs to be installed facing up towards the rear of the cabinet
to promote proper airflow. Failure to install the shelves properly is considered user error and is
not covered by warranty.
• If the unit has recently been transported on its side, please let the unit stand upright for a
minimum of 24 hours before plugging it in.
• Make sure that the unit has reached the desired temperature before loading the unit with
products. This unit is meant for keeping cold products cold, not chilling warm products.
• Make sure that there is proper ventilation around the unit in the area where it will operate.
• Make sure all accessories are installed (i.e., shelves, shelf clips, casters) before plugging the
unit in.
• Do not attempt to remove or repair any component of the unit. Consult an authorized service
technician for servicing/repair.
• Do not sit/stand on or inside the unit.
• Please read through the manual in its entirety.
• This unit is designed to perform in a temperature-controlled environment at 60% relative
humidity. The unit should be located away from doors, air ducts, and fans that could disrupt
airflow and negatively impact performance.
Cabinet Location Guidelines
• Install the unit on strong and leveled surfaces.
- If the surface is uneven, the unit may be noisy.
- The unit may malfunction if the surface is uneven.
• Install the unit in an indoor, well-ventilated area.
- For best performance, always maintain 6" of clearance on both sides and the back of the unit.
- Do not use outdoors. For indoor use only.
- Avoid direct sunlight.
• Avoid installation in a high humidity and/or dusty area.
- Humidity above 60% can cause the unit to rust, collect condensation, and may decrease
p roduct efficiency.
- Dust collected on condenser coil will cause unit to malfunction.
- Malfunction due to temperatures above 75°F, humidity above 60%, or improperly maintained
condenser coil will void the warranty.
• Select a location away from heat and moisture-generating equipment.
- Ambient temperatures above 75°F may cause the compressor to malfunction.
- Malfunction due to ambient temperatures above 75°F will void warranty.
- Do not install the unit inside a closet or alcove.
www.AvantcoRefrigeration.com
User Manual
Commercial Sandwich Prep Tables
- 3 -