Avantco 447APST60 Kullanıcı Kılavuzu - Sayfa 7
Ticari Gıda Ekipmanları Avantco 447APST60 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Avantco 447APST60 8 sayfaları. Commercial sandwich prep tables
Ayrıca Avantco 447APST60 için: Kullanıcı Kılavuzu (7 sayfalar)
Sayfayı Yazdır
Cleaning the Condenser Coil
•
For efficient operation, keep the condenser surface free of dust, dirt, and lint.
•
We recommend cleaning the condenser coil at least once per month.
•
A dusty condenser may lead to high energy consumption, less cooling effectiveness, and
compressor damage.
Condenser Coil Cleaning Instructions:
The condenser coil is located at the bottom behind the panel.
1.
Disconnect the electrical power from the unit.
2. Remove the front cover and base cover with a screwdriver.
3. Using a soft brush and/or vacuum, remove the dirt, lint, etc. from the finned condenser coil in
a vertical direction.
4. Clean the condenser with a commercial condenser coil cleaner, available from any kitchen
equipment retailer. Ex: Nobel Chemical Tech Line.
5. After cleaning, straighten any bent condenser fins with a fin comb.
6. When finished, be sure to reinstall the front cover and base cover.
7. Reconnect the electrical power to the unit.
Troubleshooting:
Compressor Not Running:
Fuse blown or circuit breaker tripped.
Power cord unplugged.
Thermostat set too high.
Cabinet in defrost cycle.
Condensing Units Run For Long Periods of Time:
Excessive amount of warm product placed in
cabinet.
Prolonged door opening or door ajar.
Door gasket(s) not sealing properly.
Dirty condenser coil.
Evaporator coil iced over.
www.AvantcoRefrigeration.com
User Manual
Commercial Sandwich Prep Tables
Replace fuse or reset circuit breaker.
Plug in power cord.
Set thermostat to lower temperature.
Wait for defrost cycle to finish.
Allow adequate time for product to cool down.
Ensure doors are closed when not in use.
Avoid opening doors for long periods of time.
Ensure gaskets are snapped in completely.
Remove gasket and wash with soap and water.
Check condition of gasket and replace if
necessary.
Clean the condenser coil.
Unplug unit and allow coil to defrost. Make
sure thermostat is not set too cold. Ensure that
door gasket(s) are sealing properly.
- 7 -