IKEA RENGJORD Manuel - Sayfa 8

Bulaşık Makinesi IKEA RENGJORD için çevrimiçi göz atın veya pdf Manuel indirin. IKEA RENGJORD 23 sayfaları.
Ayrıca IKEA RENGJORD için: Montaj Talimatları Kılavuzu (40 sayfalar)

Sayfayı Yazdır

CONTROLS & SETTINGS

Status Window

The STATUS window, available on some models, indicates the following activity:

1-24h

Number of delay start hours.

The last hour will count down

in minutes.

MINUTES

Number of minutes left in

cycle (1-199).

User Instruction Code

Instruction

Problem/Condition

Code

Displayed

This indicates the door

has been left open or

not properly latched.

Soft Power Failure: PF is displayed if a power outage occurs during a wash

cycle. The wash cycle will be paused temporarily and resume once power is

restored if the door has not been opened.

Hard Power Failure: A hard power failure means the unit will not operate

until power is restored. Pressing start within 18 hours of loss of power will

resume power at the point of cycle interruption.

Error Code

Displayed

Problem

Error Code*

i10

A low fill has been

detected.

i20; i40; iF0

Clogged filters or a

restricted drain line has

been detected.

i30

A leak or overflow of

water has been detected

in the bottom pan.

i50

A problem has been

detected with the drain

or wash motor.

i60

A problem has been

detected with the water

heating system.

iC0

A problem has been

detected with the

electronic control system.

In all Error Code instances, if pressing the Cancel button or turning power off at the breaker

for 5 min. does not solve the problem, contact the Authorized Service Center stated in the

warranty section.

Close will scroll across the

status window indicating the

door needs to be closed.

L0–L6.

Level of Rinse Aid dosage.

Solution

Ensuring the door is properly latched will clear

the display. This does not indicate a problem

with your dishwasher and service will not need

to be contacted.

Solution

Look for a pinched water supply line, or water

shutoff is not completely opened.

Check and clean both filters and sump

area and check for a pinched or blocked

drain hose. If the drain line is attached to a

disposer, check that the knockout plug has

been removed.

Look for loose connections at the water inlet

valve and ensure the unit is properly leveled.

Pressing the cancel button or turning power

off at the breaker for 5 min. should clear this

error code and the unit can be restarted.

If this does not resolve the problem,

service will need to be called.