Makita 4340FCT Teknik Bilgiler - Sayfa 7

Elektrikli Alet Makita 4340FCT için çevrimiçi göz atın veya pdf Teknik Bilgiler indirin. Makita 4340FCT 16 sayfaları. Jig saw
Ayrıca Makita 4340FCT için: Kullanım Kılavuzu (17 sayfalar), Teknik Özellikler (2 sayfalar), Parça Dağılımı (3 sayfalar), Kullanım Kılavuzu (13 sayfalar)

Makita 4340FCT Teknik Bilgiler
R
epair
5. Lubricate the parts assembled in gear housing cover with referring to "< 1 > Lubrication " at page 2.
6. Aligning slider to needle bearing 407 on crank complete, assemble gear housing cover section to gear housing
as illustrated in Fig. 11 . Do not forget to assemble packing between gear housing cover
and gear housing. See Fig.11A
Slider
Gear housing
cover
Align slider to needle bearing 407
on crank complete
< 7 > Disassembling blade holder
1. Disassemble rod with referring to "< 5 > Disassembling gear housing cover section" at page 5.
2. Disassemble dust cover, and then disassemble retaining ring R-18. as illustrated in Fig. 12.
So blade holder and torsion spring 15 can be separated from rod as illustrated in Fig. 12A.
Dust cover
Retaining
ring R-18
Blade holder
Fig. 12
< 8 > Assembling blade holder
1. Apply MAKITA grease FA No.2 to push pin and set it in the hole of rod. And assemble torsion spring 15 to rod by
inserting its tail shown in Fig. 13 into the hole of rod.
2. Set blade holder to rod as illustrated in Fig. 14. And bring the tail of torsion spring 15 to the space A of blade
holder as illustrated in Fig. 15.
Push pin
Torsion spring 15
Insert this tail into
the hole of rod.
Needle bearing 407
Crank complete
Balance plate
Fig. 11
Be careful, not to lose push pin,
when disassembling.
Rod
Rod
Aligning the mark
of blade holder and
push pin, set blade holder
Fig. 13
to rod.
4 pcs. of
Tapping screws CT 4 x 16
Safety wire
Gear housing
4340T, 4340CT, 4340FCT
Blade holder
Fig. 12A
Bring this tail to the
space A of blade
holder by turning
clockwise.
Fig. 14
P 7 / 16
Gear housing cover
Packing
Fig. 11A
Torsion spring 15
Blade holder
Fig. 15
Space A