Makita 4340FCT Технічна інформація - Сторінка 7

Переглянути онлайн або завантажити pdf Технічна інформація для Електроінструмент Makita 4340FCT. Makita 4340FCT 16 сторінок. Jig saw
Також для Makita 4340FCT: Інструкція з експлуатації (17 сторінок), Технічні характеристики (2 сторінок), Розбивка на частини (3 сторінок), Інструкція з експлуатації (13 сторінок)

Друкувати сторінку

epair

5. Lubricate the parts assembled in gear housing cover with referring to "< 1 > Lubrication " at page 2.

6. Aligning slider to needle bearing 407 on crank complete, assemble gear housing cover section to gear housing

as illustrated in Fig. 11 . Do not forget to assemble packing between gear housing cover

and gear housing. See Fig.11A

Slider

Gear housing

cover

Align slider to needle bearing 407

on crank complete

< 7 > Disassembling blade holder

1. Disassemble rod with referring to "< 5 > Disassembling gear housing cover section" at page 5.

2. Disassemble dust cover, and then disassemble retaining ring R-18. as illustrated in Fig. 12.

So blade holder and torsion spring 15 can be separated from rod as illustrated in Fig. 12A.

Dust cover

Retaining

ring R-18

Blade holder

Fig. 12

< 8 > Assembling blade holder

1. Apply MAKITA grease FA No.2 to push pin and set it in the hole of rod. And assemble torsion spring 15 to rod by

inserting its tail shown in Fig. 13 into the hole of rod.

2. Set blade holder to rod as illustrated in Fig. 14. And bring the tail of torsion spring 15 to the space A of blade

holder as illustrated in Fig. 15.

Push pin

Torsion spring 15

Insert this tail into

the hole of rod.

Needle bearing 407

Crank complete

Balance plate

Fig. 11

Be careful, not to lose push pin,

when disassembling.

Rod

Aligning the mark

of blade holder and

push pin, set blade holder

Fig. 13

to rod.

4 pcs. of

Tapping screws CT 4 x 16

Safety wire

Gear housing

4340T, 4340CT, 4340FCT

Blade holder

Fig. 12A

Bring this tail to the

space A of blade

holder by turning

clockwise.

Fig. 14

P 7 / 16

Gear housing cover

Packing

Fig. 11A

Torsion spring 15

Blade holder

Fig. 15

Space A