Makita 4351FCT Teknik Bilgiler - Sayfa 10

Elektrikli Alet Makita 4351FCT için çevrimiçi göz atın veya pdf Teknik Bilgiler indirin. Makita 4351FCT 15 sayfaları. Jig saw
Ayrıca Makita 4351FCT için: Teknik Özellikler (2 sayfalar), Parça Dağılımı (3 sayfalar), Kullanım Kılavuzu (13 sayfalar), Kullanım Kılavuzu (13 sayfalar), Kullanım Kılavuzu (9 sayfalar)

epair

[11] Disassembling armature

1. With referring to the following section, disassemble Head covers L and R, and gear housing cover.

[4] Disassembling Head cover section in page 3

[5] Disassembling Gear housing cover section" at page 4

2 . Remove Rear cover by unscrewing 4 x 18 Tapping screw. And then, remove Carbon brushes. (Fig. 34)

Fig. 34

Rear cover

3. Remove Retaining ring S-8, and separate Crank complete, Balance plate and Gear complete from the shaft of Gear

housing as illustrated in Fig. 35.

Note: It is not necessary to remove M4x12 Hex socket head bolt, Crank complete and Gear complete from

Balance plate.

Be careful not to lose Needle bearing 407.

Fig. 35

Retaining S-8

Crank complete

Gear complete

Balance plate

4. Remove four 4x30 Tapping screws, and then separate Gear housing from Motor housing.

Separate Armature from Gear housing by striking Gear housing with plastic hammer. (Fig. 36)

Fig. 36

4x30 Tapping

screws

5. Remove Self lock with slotted screwdriver. Magnet sleeve, Wave washer 6 and Rubber ring 19 are removed from

Armature shaft. Fig. 37.

Fig. 37

Self lock

Carbon brushes

Tapping screw 4x18

Needle bearing 407

Gear housing

Armature

Motor housing

Insulation washer

Ball baring 607

Rubber ring 19

Wave washer 6

Magnet sleeve (It is not used for model 4351T.)

P 10 / 15