CORNING Pretium EDGE ETM-7B-Q Kurulum ve Test - Sayfa 7

Kontrol Ünitesi CORNING Pretium EDGE ETM-7B-Q için çevrimiçi göz atın veya pdf Kurulum ve Test indirin. CORNING Pretium EDGE ETM-7B-Q 9 sayfaları. Tap module

Sayfayı Yazdır

CORNING Pretium EDGE ETM-7B-Q Kurulum ve Test

Step 6:

Clean and install an LC to LC jumper-

Reference Jumper no. 2 (RJ2) into M1

and the LC adapter (Figure 9).

Step 7:

Verify that the RJ1/ RJ2 mated pair are

acceptable with a loss ≤0.15 dB.

Step 8:

Disconnect RJ2's LC connector from the

LC adapter and protect it with a clean

dust cap until you are ready to start the

system testing.

Step 9:

Clean and install an LC to LC jumper-

Reference Jumper no.3 (RJ3) into M2

and the LC adapter (Figure 10).

Step 10: Verify that the RJ1/RJ3 mated pair are

acceptable with a loss ≤0.15 dB.

Step 11:

Disconnect RJ1's LC connector from

the LC adapter and protect it with a

clean dust cap.

Step 12: Leave the LC adapter on the end of RJ3 for the remainder of this procedure since it will be

required for mating to the TAP port test harness.

8.3

Referencing is now complete. Move the Light Source and RJ1 to the front of the Tap module; move

M2, RJ3, and the LC adapter to the end of the Tap harness; and move M1 and RJ2 to the Pretium EDGE

modules at the far end of the system (See Figure 11).

IMPORTANT: From this step on, do NOT disconnect the connectors on either the Light Source or meter port

adapters.

STANDARD RECOMMENDED PROCEDURE 003-126 | ISSUE 1 | OCTOBER 2012 | PAGE 7 OF 9

multimode only

RJ1

Do NOT

disconnect

Light

Source

HPA-0759

Dust cap

multimode only

RJ 1

Do NOT

disconnect

Light Source

HPA-0760

adapter

Reference

Jumper no. 2

RJ2

Do NOT

disconnect

Figure 9

Do NOT

disconnect

adapter

RJ3

0.15 dB

0.3 dB

Figure 10

0.15 dB

RJ2