KitchenAid Undercounter Dishwasher 4171206 Kurulum Talimatları Kılavuzu - Sayfa 4

Bulaşık Makinesi KitchenAid Undercounter Dishwasher 4171206 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. KitchenAid Undercounter Dishwasher 4171206 8 sayfaları. Undercounter dishwasher

Sayfayı Yazdır

copper,

the copper

should

be 12" plus a

12" length of flexible

hose attached

to the end.

Figure 5

If drain hose connection

is less

than 20" above the floor, the hose

must form a loop using 38" OD

copper tubing 20 inches above the

floor. Make sure there are no kinks

in the hose or copper tubing.

Product Damage

All solder connections

must be

made before the water line is

connected to the dishwasher

to prevent damage to the inlet

valve.

'0 Do Not solder within 6" of inlet

valve. The plastic part of the

1 water inlet valve could be

damaged.

If connection to an air gap is

required, air gap kits are available

from local plumbing sources.

Recommended

methods:

Air-gap

kit

Install air gap according to kit

instructions.

Connect the air gap to a waste

tee or disposer using a rubber

connector. Most disposers have

7/8" connectors or special

connectors are available at plumbing

supply houses. Be sure to remove

the disposer knockout or plug

before connecting the drain hose.

Air-gap

tor

Alternate

methods:

If local plumbing codes permit,

dishwasher drain hose may be

connected directly to a waste tee

or directly to a waste disposer.

The waste tee connection MUST be

made ahead of the trap and a

minimum of 20 inches above the

floor. Most disposers have 7/8"

connectors or special connectors

are available at plumbing supply

houses. Be sure to remove the

disposer plug before connecting

the drain hose.

Page 4