Makita BCG140 Kullanım Kılavuzu - Sayfa 6

Elektrikli Alet Makita BCG140 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Makita BCG140 12 sayfaları. Cordless caulking gun
Ayrıca Makita BCG140 için: Teknik Bilgiler (11 sayfalar)

Sayfayı Yazdır

Overloaded:

•

The tool is operated in a manner that causes

it to draw an abnormally high current.

In this situation, release the switch trigger on

the tool and stop the application that caused

the tool to become overloaded. Then pull the

switch trigger again to restart.

If the tool does not start, the battery is

overheated. In this situation, let the battery

cool before pulling the switch trigger again.

Low battery voltage:

•

The remaining battery capacity is too low

and the tool will not operate. In this situation,

remove and recharge the battery.

NOTE:

The overheat protection works only with a battery

cartridge with a star mark.

012128

Speed adjusting dial

013560

The tool speed can be adjusted by turning the dial.

Higher speed is obtained when the dial is turned in the

direction of number 5, lower speed is obtained when it is

turned in the direction of number 1.

NOTE:

The speed adjusting dial can be turned only as far

•

as 5 and back to 1. Do not force it past 5 or 1, or

the speed adjusting function may no longer work.

Depending on the type and condition of caulking

•

material, the rod may get clogged when operating

with low speed. In that case set the speed

adjusting dial higher.

1. Star marking

1. Speed adjusting

dial

Overload warning lamp

013557

The warning lamp flickers in red when the tool is

overloaded. If the load reaches some point, the lamp

keeps lighting in red and the tool stops. To restart the

tool, release the trigger and pull the trigger again.

NOTE:

Check what causes the overload when the lamp flickers

or lights up. Change the parameter of the speed

adjusting dial lower, or increase the diameter of the

nozzle.

Switch action

CAUTION:

Before inserting the battery cartridge into the tool,

•

always check to see that the switch trigger

actuates properly and returns to the "OFF"

position when released.

When not operating the tool, push the trigger-lock

•

button from A side to lock the switch trigger in the

OFF position.

013559

To prevent the switch trigger from accidentally pulled,

the trigger-lock button is provided.

To start the tool, push the trigger-lock button from B side

and pull the switch trigger. Tool speed is increased by

increasing pressure on the switch trigger. Release the

switch trigger to stop.

After use, press in the trigger-lock button from A side.

1. Warning lamp

1. Lock lever

2. Switch trigger