Makita BJV180 Teknik Bilgiler - Sayfa 6
Elektrikli Alet Makita BJV180 için çevrimiçi göz atın veya pdf Teknik Bilgiler indirin. Makita BJV180 13 sayfaları. Cordless jig saw
Ayrıca Makita BJV180 için: Parça Dağılımı (3 sayfalar), Şartname Sayfası (2 sayfalar), Kullanım Kılavuzu (13 sayfalar), Kullanım Kılavuzu (13 sayfalar), Kullanım Kılavuzu (13 sayfalar), Kullanım Kılavuzu (18 sayfalar)
Sayfayı Yazdır
R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -2. Gear Housing Cover Section (cont.)
ASSEMBLING
4) Put Slider on Rod while aligning the two holes of Slider with the hole of Rod, and insert Pin 4 (268090-1) through
the aligned through holes from left side as illustrated to right in Fig. 14.
5) Swivel Slider in the direction of the black arrow, and insert two Linear guides to each side of Slider. (Fig. 15)
Fig. 14
Gear housing cover complete
Rod
Slider
6) Lay down Linear guides on Gear housing cover complete while lifting up Leaf spring, and place Leaf spring on
Linear guides. (Fig. 16)
7) Push Slider to the center of Linear guides. Fasten Leaf spring through Linear guides to Gear housing cover complete
with two M4x10 Pan head screws, then fasten Linear guides to Gear housing cover complete with the other two
M4x10 Pan head screws. (Fig. 17)
8) Assemble Stop ring E-3 to Pin 4 (268090-1) as illustrated in Fig. 18.
Note: Check whether Slider reciprocates smoothly on Linear guides. If not, Linear guide(s) can be tilted.
In this case, reassemble Linear guide(s) to Gear housing cover complete correctly.
Fig. 16
[Gear housing cover section viewed from A]
Linear guide
A
Gear housing cover complete
Fig. 17
Push Slider to
the center of
Linear guides.
Linear guide
Pin 4
(268090-1)
Slider
Leaf spring
Pan head screw M4x10 (4pcs)
Leaf spring
Fig. 15
Slider
Rod
Linear guide, set in place
between Leaf spring and
Gear housing cover complete
Fig. 18
Linear guide
Slider
Pin 4 (268090-1)
Rod
P 6/13
Linear guide (2pcs)
Rod
Leaf spring
Stop ring E-3