Lexmark 25A0452 - C 736dtn Color Laser Printer Hızlı Referans

Yazıcı Lexmark 25A0452 - C 736dtn Color Laser Printer için çevrimiçi göz atın veya pdf Hızlı Referans indirin. Lexmark 25A0452 - C 736dtn Color Laser Printer 2 sayfaları. Color laser printers
Ayrıca Lexmark 25A0452 - C 736dtn Color Laser Printer için: Tepsi Modülü Kurulum Kılavuzu (1 sayfalar), Tepsi Modülü Kurulum Kılavuzu (2 sayfalar), Bağlantı Kılavuzu (5 sayfalar), Baskı Kılavuzu (3 sayfalar), Broşür ve Teknik Özellikler (6 sayfalar), Yazdırma Kılavuzu (9 sayfalar), Medya El Kitabı (3 sayfalar), Menü Haritası (3 sayfalar), Sarf Malzemeleri Kılavuzu (2 sayfalar), Kurulum (2 sayfalar), Bilgi Kılavuzu (1 sayfalar), Hızlı Kılavuz (4 sayfalar)

Quick Reference

Loading paper

Do not remove trays while a job prints or while Busy blinks on the

printer control panel. Doing so may cause a jam.

Grasp the handle, and then pull the tray out.

Notice the size indicators on the bottom of the tray. Use these

indicators to help position the guides.

Squeeze the width guide tabs as shown, and then slide the

guide to the correct position for the size of paper being loaded.

Notice the load line on the left side of the paper tray: it indicates

the maximum height for loading paper.

Squeeze the length guide tabs together, and then slide the

length guide to the correct position for the size of paper being

loaded.

Note: The length guide has a locking device. To unlock the

tray, slide the button on top of the length guide to the left as

shown. To lock the tray once a length has been selected, slide

the button back to the right.

Flex a stack of paper back and forth to loosen the sheets, and

then fan them. Do not fold or crease the paper. Straighten the

edges on a level surface.

Load the paper stack with the recommended print side faceup.

Load the stack toward the back of the tray as shown.

Align the tray, and then reinsert it.

If a jammed sheet is visible, then pull it out gently. If the jam is not

visible, then complete the step that corresponds to the error

message displayed on the printer control panel.

Note: To avoid overexposing the photoconductors, do not leave

the front door open longer than 10 minutes.

Clearing jams behind the front door

Remove Tray 1, and then open the front door.

•

Pull straight up to remove the jammed paper.

•

Pull the paper forward if it is lodged under the

photoconductors.

Note: You may need to remove the photoconductors if

the paper is lodged too tightly under them.

•

Pull the paper up and out to remove it from behind the

toner cartridge area.