Airgineers Micro Drone Talimatlar Kılavuzu - Sayfa 3

Dronlar Airgineers Micro Drone için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Airgineers Micro Drone 16 sayfaları.

Building the drone

Connecting the camera to the canopy

STEP 1

STEP 2

Insert the two screws to hold camera in place with the camera clip.

Secure the clip to the inside top of the canopy using one of the screws,

then secure the clip to the rear of the canopy below the camera using

the other screw.

Make sure the camera is the correct way round - Wires pointing down

Airgineers Manual version 1.0 2022

If not already done,

connect the camera and

the board connectors

together.

Insert the camera into

the hole provided in the

canopy. The camera is

secured in position by

fitting the camera clip.

Camera

Screw

Connecting the Board to the frame

STEP 1

Push fit the rubber frame mounts

onto the four corners of the flight

controller.

STEP 3

Insert the two screws through the

canopy into the frame, to secure

the canopy in position.

You might want to leave fitting of

the canopy, until Binding the Drone

to the Transmitter has been done

( see page 6).

STEP 2

Gently push the board onto the

frame aligning the pegs on the frame

with the rubber frame mounts. Make

sure the frame and the board are

facing the right direction (see below).

Notch in frame indicates front

Battery cable and ariel indicates

the back of the board