Gardena 1753 Kullanım Talimatları Kılavuzu - Sayfa 5

Su Pompası Gardena 1753 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Gardena 1753 17 sayfaları. Pressure tank unit

Connect the hose to

the suction side:

Art. 1723 /

Art. 1724

Connect hose to the

output side:

A vacuum-tight suction hose must be used e. g.:

– GARDENA Suction Unit Art. no. 1411 / 1418 / 1412 or

– GARDENA Bore Hole Suction Hose Art. no. 1729.

Do not use any water hose snap connection system components

on the intake side!

v Connect the suction hose

connection

Connect the suction hoses

a connection piece (e.g. Art. no. 1723/1724)

side connection and screw in place so that they are airtight.

To reduce the pump repriming time, we recommend using

a suction hose with backflow preventer, which prevents the

suction hose emptying automatically when the Pressure Tank Unit

is switched off.

For suction heights exceeding 4 m also secure the suction hose

(e. g. by fastening it to a wooden post) to relieve the pump of the

weight of the suction hose.

If very fine dirt is present in the pumping medium, we

recommend the use of a GARDENA Pump Preliminary Filter

Art. no. 1730 / 1731.

Note:

Use pressure-tight GARDENA hoses, 19 mm (3/4") in diameter,

in connection with the GARDENA Quick-Release Threaded

Connector with 33.3 mm (G1) internal thread, Art. no. 7109,

and the GARDENA Suction and High Pressure Connector,

Art. no. 7120, for 19 mm (3/4") hoses and a GARDENA Hose

Clip, Art. no. 7192.

Under no circumstances use these hoses on the suction

side.

v Connect delivery hose

v Tip: If permanent pipes are installed, they must be laid at an

ascending angle in order to allow the water to flow back into

the pump on the pressure side.

with the intake side

of the pump.

without a threaded connector via

to the delivery side connection

with the intake