Broadata Link Bridge LBC-HDMI-R-WP Kullanıcı Kılavuzu - Sayfa 12
Alıcı Broadata Link Bridge LBC-HDMI-R-WP için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Broadata Link Bridge LBC-HDMI-R-WP 20 sayfaları. Hdmi wall plate hdbaset transmission system
Sayfayı YazdırLBC-HDMI-T/R-WP User's Manual
Link Bridge
HDMI Wall Plate HDBaseT Transmission System
TM
Figure 3-1
Power Connection
Note 1: During installation, the installer may need to connect
the power supply output to an appropriate Listed NEC type
cable before it is routed behind a wall. Simply routing the power
supply output cable behind a wall will most likely not comply
with applicable installation requirements. Unit should only be
powered by a power source that is Listed (NEC) Class 2 or a
Listed ITE Power Supply marked/rated as LPS or Limited Power
Source.
Note 2: The installation shall be in accordance with the applicable
provisions of the National Electrical Code ANSI/NFPA 70, Article
725 and the Canadian Electrical Code, Part 1, Section 16.
Note 3: The power supply shall not be permanently fixed to the
building structure or similar structures.
Note 4: The power supply shall not be located within
environmental air handling spaces or within the wall cavity.
Note 5: The power supply is to be located within the same
vicinity as the A/V processing equipment in an ordinary location,
Pollution Degree 2, secured to the equipment rack within the
dedicated closet, podium or desk.
Broadata Technical Support, [email protected]
13