Makita 6211DH Kullanım Kılavuzu - Sayfa 8

Matkap Makita 6211DH için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Makita 6211DH 15 sayfaları. Cordless driver drill equipped with electric brake

Sayfayı Yazdır

Speed change

To change the speed, slide the speed change

lever to the "H" side for high speed or

"L" side for low speed. To slide the speed

change lever easily, pull the trigger slightly

while pushing the speed change lever. Be

sure that the speed change lever is set to

the correct position before operation. Use

the right speed for your job.

CAUTIO N :

Always

set

the speed change lever fully into the correct position. I f you operate the tool

with the speed change lever positioned halfway between the "H" side and "L" side, the

tool may be damaged.

Adjusting fastening torque

The fastening torque can be adjusted in six

stages

by turning the adjusting ring so that

the pointer on the adjusting ring points to

a number on the tool body. The fastening

torque is minimum when the pointer points

to the number 1 and maximum when

points to the

-\-

marking. The clutch will

slip

varying torque levels when the

pointer is

set a t

the numbers 1 to 5. The

clutch is designed not to slip a t the

-8-

marking.

Before actual operation, drive

trial screw into your material or a piece of duplicate

material to determine which torque level is required for a particular application.

NOTE :

The adjusting ring cannot be locked with the pointer positioned half-way between the

numbers.

Screwdriving operation

Place the point of the driver bit in the

screw head and apply pressure to the tool.

Start the tool slowly and then increase the

speed gradually.

Release

the trigger

soon

the clutch cuts in.