AEG 30" B3007H-L-B Kullanıcı Kılavuzu - Sayfa 23

Fırın AEG 30" B3007H-L-B için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG 30" B3007H-L-B 34 sayfaları. 30” built-in oven

How to Rotate Doors in the Double and Single Oven

NOTE: Side Opening Only

This should only be done by a qualified person or installer. We recommend that it be a two

person task to ensure support of the heavy door apparatus during changeover. Damage done to

the appliance during a door rotation may effect the warranty provision for the appliance.

Stage1:

REMOVE THE BOTTOM DOOR FOR DOUBLE OVEN OR THE MAIN DOOR FOR

SINGLE OVEN

a) Remove the screws fixing the hinge to the oven front frame, being careful to

support the door, then remove the door and place in a safe place

b) Remove the door catch by removing the two screws top and bottom of the door

latch on the opposite side of the oven front frame to the hinges

c) Remove the screws fitted in the thread holes in the oven front frame to allow the re-

positioning of the door hinge to the opposite side

Stage 2: (FOR DOUBLE OVENS ONLY) REMOVE THE TOP DOOR AS PER STAGE 1

ABOVE AND LEAVE IN POSITION THE FITTED MIDDLE SPACER

Remove the screws fixing the bracket of the middle spacer profile

Remove the screws fixing the hinge of the top door

Remove the door with the middle profile fixed to the hinge, rotate 180° place in a safe

place ready for re-affixing

Stage 3: FITTING THE DOORS – FOR DOUBLE OVENS AND SINGLE OVENS

For Double Oven re-fit the bottom door first by fixing the hinges with their screws; fix

also the bracket of the middle spacer profile at the same time

Re-fit the top door after having rotated it by 180°

Re-fit the two door catches in the appropriate oven front frame position – minor

adjustment available later to ensure accurate receipt of door striker pin

10.

Re-fit the remaining screws in the thread holes in the oven front frame

The changeover is complete – please check that all screws are fully tightened and that the

striker pin is accurately received by the re-located door latch.

Changing the light globe

The light globe is located behind the glass cover and is a screw-in type.

To change a light globe:

1- Gently lever out the glass cover only.

2- Pull the light globe and push in a replacement globe.

3- Replace the glass cover making sure it fits correctly into place.

NOTE:

Recommended globe: Halogen 40W