AEG 30" B3007H-L-B Kullanıcı Kılavuzu - Sayfa 24
Fırın AEG 30" B3007H-L-B için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG 30" B3007H-L-B 34 sayfaları. 30” built-in oven
Sayfayı Yazdır
F -
Trouble Shooting Guide
Symptom
No power supplied to appliance
Oven power is on but appliance does not
operate
Oven power is on but there is no heat
Rubber seal has gap/s at bottom and
ends do not meet
Display is flashing, is only part
illuminated or is cycling through various
displays.
G -
Installation instructions.
INFORMATION FOR THE INSTALLER
THE GRAB HANDLES MUST BE USED TO MOVE THE OVEN.
WHEN THE OVEN IS HALF FITTED IN THE CABINET, IT IS POSSIBLE TO REMOVE THE
TWO HANDLES BY UNSCREWING THE FOUR FIXING SCREWS.
DO NOT LIFT OVEN BY THE FRONT DOOR AS THIS WILL DAMAGE THE OVEN
WARNING:
Installation must comply with Standards North America (within North America) wiring rules, as
well as your local electrical and building codes and regulations and any other applicable
requirements. Your appliance must be properly installed and grounded by a qualified and
licensed technician.
Incorrect installation of the appliance, resulting from the kitchen maker not following the detailed
installation specifications, can affect the appliance performance. Ovens incorrectly installed may
invalidate the warranty and we strongly recommend that the oven cavity and venting be prepared,
as described, in the following specifications. This is critical to appearance, oven performance and
safety.
Measurements
Please note that all dimensions provided are in millimeters (mm.) The sizes allow for only a small
degree of error so all cut-outs must be precise and square. To ensure the cabinet is well finished,
the cut edges must also be square and care taken to ensure the cut edges are free of chips.
Remedy
Has the power been disconnected? Check the meter
box. Has the main fuse or circuit breaker blown or
tripped?
Oven may be set on AUTO (see auto programmed
cooking)
Oven may be set on AUTO
Oven temperature may be set OFF
Mode may be on incorrect selection
Correct - doors are sealed this way for oven venting
purposes
Turn power supply to appliance off, wait 30 seconds and
turn power on. Reset clock
24