AEG B3007H-B Kullanıcı Kılavuzu - Sayfa 23

Fırın AEG B3007H-B için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG B3007H-B 39 sayfaları. 30” built-in oven

F -

Trouble Shooting Guide

Symptom

No power supplied to appliance

Oven power is on but appliance does not

operate

Oven power is on but there is no heat

Rubber seal has gap/s at bottom and

ends do not meet

Display is flashing, is only part

illuminated or is cycling through various

displays.

G -

Installation instructions.

INFORMATION FOR THE INSTALLER

THE GRAB HANDLES MUST BE USED TO MOVE THE OVEN.

WHEN THE OVEN IS HALF FITTED IN THE CABINET, IT IS POSSIBLE TO REMOVE THE

TWO HANDLES BY UNSCREWING THE FOUR FIXING SCREWS.

DO NOT LIFT OVEN BY THE FRONT DOOR AS THIS WILL DAMAGE THE OVEN

WARNING:

Installation must comply with Standards North America (within North America) wiring rules, as

well as your local electrical and building codes and regulations and any other applicable

requirements. Your appliance must be properly installed and grounded by a qualified and

licensed technician.

Incorrect installation of the appliance, resulting from the kitchen contractor not following the

detailed installation specifications, can affect the appliance performance. Ovens incorrectly

installed may invalidate the warranty and we strongly recommend that the oven cavity and

venting be prepared, as described, in the following specifications. This is critical to appearance,

oven performance and safety.

Measurements

Please note that all dimensions provided are in millimeters (mm.) The sizes allow for only a small

degree of error so all cut-outs must be precise and square. To ensure the cabinet is well finished,

the cut edges must also be square and care taken to ensure the cut edges are free of chips.

Remedy

Has the power been disconnected? Check the meter

box. Has the main fuse or circuit breaker blown or

tripped?

Oven may be set on AUTO (see auto programmed

cooking)

Oven may be set on AUTO

Oven temperature may be set OFF

Mode may be on incorrect selection

Correct - doors are sealed this way for oven venting

purposes

Turn power supply to appliance off, wait 30 seconds and

turn power on. Reset clock