Garmin NavComm SL30 Kullanıcı Kılavuzu - Sayfa 11
Araç Navigasyon sistemi Garmin NavComm SL30 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Garmin NavComm SL30 48 sayfaları. Vhf transceiver
Ayrıca Garmin NavComm SL30 için: Hızlı Referans Kılavuzu (2 sayfalar), Kurulum (2 sayfalar)
Sayfayı YazdırSelecting a Comm Frequency
New frequencies are first selected as a Standby frequency
and then toggled to the Active side when desired. While
viewing the Standby frequency display, use the
SMALL
and
the desired frequency.
COM
1. Press
annunciator above the
LARGE
2. Turn the
MHz increments. The MHz selection range is between
118 and 136 in one MHz steps.
SMALL
3. Turn the
25 kHz increments. The kHz selection range is
between 000 and 975 kHz in 25 kHz steps. Note that
only two digits are displayed to the right of the decimal
point.
LARGE
4. Turn the
increase and counterclockwise to decrease the
frequency values. Standby frequency selection is not
inhibited during transmit.
FLIP/FLOP
5. Press the
frequency to the Active frequency.
Selecting a Nav Frequency
The selection of Nav frequencies is the same as for the
Comm frequencies. The annunciator above the
button will light.
NAV
1. Press
LARGE
2. Turn the
MHz increments. The MHz selection range is between
108 and 117 in one MHz steps.
SMALL
3. Turn the
50 kHz increments.
FLIP/FLOP
4. Press the
frequency to the Active frequency.
You cannot display both Nav and Comm
frequencies at the same time.
knobs on the right side of the SL30 to select
to reach the Comm radio function. The
COM
knob to change the values in one
knob to change the values in
SMALL
and
button to toggle the Standby
to reach the Nav radio function.
knob to change the values in one
knob to change the values in
button to toggle the Standby
Note
Getting Started
button will light.
knobs clockwise to
LARGE
NAV
5