Garmin GNC 420 Pilot El Kitabı Eki - Sayfa 19

Aviyonik Ekran Garmin GNC 420 için çevrimiçi göz atın veya pdf Pilot El Kitabı Eki indirin. Garmin GNC 420 27 sayfaları. 400/500 series gts 8xx interface
Ayrıca Garmin GNC 420 için: Talimatlar Kılavuzu (6 sayfalar), Pilot El Kitabı Eki (4 sayfalar), Hızlı Referans (17 sayfalar), Hızlı Referans (23 sayfalar), Pilot El Kitabı Eki (22 sayfalar), Pilot İşletim El Kitabı (8 sayfalar)

All information in this section pertaining to the display and control of the Ryan 9900B TCAD also

applies to the Ryan 9900BX TCAD except for the following:

• TCAS-like symbology is used in the 9900BX as opposed to the 9900B (similar to SKYWATCH).

• Altitude modes are available similar to SKYWATCH (normal, look up, look down, unrestricted).

• Ranges are manually controlled instead of being automatically re-sized to the current shield.

• Trafﬁ c display range selections are different:

• Ryan 9900B— range is slaved to current shield size.

• Ryan 9900BX— 2 nm, 2 and 6 nm, 6 and 12 nm, 12 and 24 nm.

Refer to the Ryan TCAD Pilot's Guide for a detailed description of the Ryan TCAD System.

The Ryan TCAD (Traffic and Collision Alert Device) is an on-board air traffic display used to identify

potential collision threats. TCAD computes relative altitude and range of threats from nearby Mode C and

Mode S-equipped aircraft. TCAD will not detect aircraft without operating transponders and those that

are beyond radar coverage. TCAD, within defined limits, creates a shield of airspace around the aircraft,

whereby detected traffic cannot penetrate without triggering an alert.

SECTION 4

RYAN TCAD INTERFACE

Section 4

Ryan TCAD Interface

See the Ryan TCAD Pilot's Handbook for a

description of the trafﬁ c symbols.