Garmin Fishfinder 240 Blue Kullanıcı El Kitabı - Sayfa 17

Deniz GPS Sistemi Garmin Fishfinder 240 Blue için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Garmin Fishfinder 240 Blue 50 sayfaları. Garmin fishfinder 160 blue owner's manual
Ayrıca Garmin Fishfinder 240 Blue için: Kullanıcı El Kitabı (50 sayfalar), Pilot El Kitabı (12 sayfalar), Teknik Özellikler (2 sayfalar), Teknik Özellikler (2 sayfalar), Kullanıcı El Kitabı (50 sayfalar), Kullanıcı El Kitabı (50 sayfalar)

Testing the Installation

While it is possible to perform some checks with the boat trailered, to

properly test the installation the boat should be in the water.

Press the Power button and the Fishfinder 160 should power on. If the

unit fails to power on, verify that the wiring adapter is seated properly in

the back of the unit, the Red and Black wires are connected to the correct

polarity, and that the 2-Amp fuse is installed and not blown. If the unit is

connected to a power supply that exceeds 18 VDC, a 'Battery Voltage High'

warning will be displayed and the unit will turn off.

As the unit powers on, it should immediately start showing the bottom.

Verify that the unit is not in the simulator mode. If the unit is in the

simulator mode, make sure that the transducer is connected to the wiring

harness.

To test the transducer installation, gradually increase the boat speed

while checking the unit operation. If the unit displays intermittently or

fails to display, verify that the transducer is aligned parallel with the bottom

and if necessary, adjust the transducer height until the unit operates

correctly. It may be necessary to make several adjustments to ensure proper

operation throughout the speed range.

When adjusting the depth of the transducer, make the adjustments in small incre-

ments. Placing the transducer too deep can adversely affect the boat's performance

and place the transducer at greater risk of striking underwater objects.

Installation

Testing the Installation