Garmin TR-1 Gold Kullanıcı El Kitabı - Sayfa 27

Deniz GPS Sistemi Garmin TR-1 Gold için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Garmin TR-1 Gold 38 sayfaları. Throttle actuator
Ayrıca Garmin TR-1 Gold için: Temel Kullanım Kılavuzu (9 sayfalar), Hızlı Referans (2 sayfalar), Montaj Talimatları (7 sayfalar), Kurulum Talimatları (4 sayfalar), Owner Handheld Hızlı Referans (2 sayfalar)

Increase throttle by pressing the Up Arrow button. Decrease throttle by pressing the Down Arrow

button. The electric throttle runs in parallel with the tiller throttle, this means that you can't reduce

the RPM with the electric throttle if the tiller throttle is set high. It is best to always run with the tiller

throttle set to idle. Be careful to set the electric throttle and tiller throttle to closed position before startin g

your outboard.

Automatic idle and resume is accomplished by pressing the Idle/Resume button. If the throttle is set

higher than idle, the Idle/ Resume function will take the engine to idle. If the throttle is sitting in the

idle position, the Idle/Resume function will return the throttle to the last "above idle" position. The

Idle/Resume button must be programmed to perform Idle/Resume and not MOB or Zigzags.

Change Heading Using Zig-Zags

If you program the Idle/Resume button for Zigzags (other), then when you press the Idle/Resume

button the pilot will begin to zigzag about the heading you were on when you pressed the button. The

zigzag angle and period are both programmable. An example zigzag path is shown in the figure below.

Throttle Up/Down

Idle/Resume Feature

Idle/Resume

Change Heading with Zigzags

Heading Hold

Boat Path