Garmin TR-1 Gold 소유자 매뉴얼 - 페이지 27
{카테고리_이름} Garmin TR-1 Gold에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin TR-1 Gold 38 페이지. Throttle actuator
Garmin TR-1 Gold에 대해서도 마찬가지입니다: 기본 작동 매뉴얼 (9 페이지), 빠른 참조 (2 페이지), 설치 지침 (7 페이지), 설치 지침 (4 페이지), 소유자 핸드헬드 빠른 참조 (2 페이지)
![Garmin TR-1 Gold 소유자 매뉴얼](/uploads/products/server2/2324242/2324242.jpg)
Increase throttle by pressing the Up Arrow button. Decrease throttle by pressing the Down Arrow
button. The electric throttle runs in parallel with the tiller throttle, this means that you can't reduce
the RPM with the electric throttle if the tiller throttle is set high. It is best to always run with the tiller
throttle set to idle. Be careful to set the electric throttle and tiller throttle to closed position before startin g
your outboard.
Automatic idle and resume is accomplished by pressing the Idle/Resume button. If the throttle is set
higher than idle, the Idle/ Resume function will take the engine to idle. If the throttle is sitting in the
idle position, the Idle/Resume function will return the throttle to the last "above idle" position. The
Idle/Resume button must be programmed to perform Idle/Resume and not MOB or Zigzags.
Change Heading Using Zig-Zags
If you program the Idle/Resume button for Zigzags (other), then when you press the Idle/Resume
button the pilot will begin to zigzag about the heading you were on when you pressed the button. The
zigzag angle and period are both programmable. An example zigzag path is shown in the figure below.
Throttle Up/Down
Throttle Up/Down
Idle/Resume Feature
Idle/Resume
Change Heading with Zigzags
27
27
Heading Hold
Boat Path