Garmin Gladiator TR-1 Kullanıcı El Kitabı - Sayfa 30
Denizcilik Ekipmanları Garmin Gladiator TR-1 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Garmin Gladiator TR-1 36 sayfaları. Garmin tr-1 marine autopilot: user guide
Ayrıca Garmin Gladiator TR-1 için: Kurulum ve Kullanım Kılavuzu (4 sayfalar), Kullanıcı El Kitabı (13 sayfalar)
Sayfayı Yazdır
13. If the tune was good or suspect download to permanent memory the parameters
you have adjusted so far (autotune). With the [Setup] LED lit, press and hold the GPS
[Select Load] button-the load LED should illuminate, press and release the [Deckmount]
button, then release the GPS [Select load] button.
Note: Press and release the [Setup] button to exit setup mode.
14. Set North. This needs to be done if any GPS or radar overlay functions are going to be used.
To run a GPS course requires that the autopilot compass is in agreement with the GPS's magnetic map. You
need to set North with the pilot in standby mode. Setting North may require a signifi cant amount of clear sea
space in front of your boat (at least 1/2 to 3/4 of a mile).
Verify that the NMEA connections for the GPS are functioning. Turn on the GPS. With the Autopilot in [Standby],
press and release [Setup] button on the handheld. Press and light up the number 4 and the number 8 LED's [Code
48]. If the [up arrow] LED lights when you hold down the [Select Load] (GPS) button, the autopilot does not
acknowledge the validity of the GPS data.
With The GPS Connected to Autopilot:
1. With the system in [STBY]
4. Press and release the
[Right Chevron] button
TWO times to illuminate
the #8 LED.
(You have
now selected
code 48)
6. Press and HOLD
the GPS [Select Load]
button. The Load LED
will illuminate on the
[Setup] Button
Set North
2. Press and release [Setup]
button once to illuminate
(left) LED
5. Run your boat at planing speed at a con-
stant heading. You will need at least 1/2 mile
of hazard free water in front of you.
7. While holding down
the [Select Load] button.
Press and Release the
[Deckmount] button quickly.
30
3. Press and release [left
chevron] button one time
to illuminate the #4 LED.
8. Release the [Select Load]
button, after [Load] LED
diminishes. The system will
power down after North is set.