Fujitsu UTY-RNRUZ2 Kullanım Kılavuzu - Sayfa 5
Klima Fujitsu UTY-RNRUZ2 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Fujitsu UTY-RNRUZ2 26 sayfaları. Remote controller (wired type)
Ayrıca Fujitsu UTY-RNRUZ2 için: Kurulum Kılavuzu (11 sayfalar)
Sayfayı Yazdır
2 Password configuration
This unit can set the following 2 kinds of passwords:
(a) Password
This is a password for administrator. Password is re-
quested by the setting which requires management. For
a description of password setting and change, refer to
[3. SETTING] →[3.8 Initial Setting]→[3-8-6 Password
Setting] .
(b) Installer password
This password is requested for important settings at
installation.
Note
If you forget your password, contact your local dealer.
3 Name of parts
(a)
(b)
(c)
(d)
(a) Touch panel display
• When the screen is touched or the Operation button
is pressed while backlight is set to Enable, backlight
lights. Backlight goes off 30 or 60 seconds after the
last operation. When backlight is set to Disable, it does
not light. For a description of backlight setting, refer to
[3 SETTING]→[3-7 Preference]→[3-7-2 Backlight Set-
ting].
• Lightly touch the touch panel with your finger tips. A
commercially available stylus pen can also be used.
If pushed with too much force or operated with a
rod, pencil, or ballpoint pen, etc., the display may be
scratched or damaged.
• Do not touch 2 or more places simultaneously. Correct
operation cannot be performed.
• When cleaning the touch panel display, setting child
safety lock prevents erroneous operation. (Refer to
[1 MONITOR] → [1-1 Monitor] → [1-1-4 Child Lock].)
When cleaning, do not use detergent or alcohol, paint
thinner, etc. It will cause accidents or loss of appear-
ance.
(b) LED lamp (Operation indicator)
Lights while the indoor unit is operating. Blinks when an
error is generated.
(c) Operation (Occupied/Unoccupied) button
Switches the occupied state. Refer to [1 MONITOR] →
[1-1 Monitor] → [1-1-1 Monitor Mode Screen] and Refer
to [4 OPERATION TIPS] → [4-5 Occupied state].
(d) Room temperature sensor (inside)
Setting is necessary to use this sensor. Refer to [3
SETTING] → [3-8 Initial Setting] → [3-8-5 R.C. Sensor
Setting].
En-4