Fujitsu Primergy RX100 S5 Başlangıç Kılavuzu - Sayfa 4

Sunucu Fujitsu Primergy RX100 S5 için çevrimiçi göz atın veya pdf Başlangıç Kılavuzu indirin. Fujitsu Primergy RX100 S5 9 sayfaları.

n Cable forming process
After connecting the peripheral devices, tie all the cables and fix them with the release tie to the cable holder provided with
the rack.
This forming process makes the cables easily recognizable even when multiple servers are installed in the rack.
�����������
������
6
Turning on the power and setting hardware
Normally, hardware settings are not required to be changed from the default.
However, in the following cases, start each utility and check/change hardware settings.
- When changing the Boot Drive
- When installing/removing optional devices
- When running remote installation
������������
"Chapter 7 Configuring Hardware and Utilities"
You can write down hardware configuration and setting values of the BIOS Setup Utility in the "Configuration Sheets" that is
available from Fujitsu PRIMERGY website (http://primergy.fujitsu.com).
1
Power on the peripheral devices such
as the display.
2
Turn the server power on.
������������
�����������
�������������
7

Installing the OS

This section explains the procedures to install the OS using ServerStart.
1
Turn on the server and insert
PRIMERGY Startup Disc immediately.
ServerStart start up. The select-media window for
the configuration file appears.
�����������
������������
������������
�����
3
Set the hardware.
If no hardware settings are performed, skip to the
next step when a message to insert the PRIMERGY
Startup Disc is displayed.
1. When the " <F2> BIOS Setup / <F12>
Boot Menu" message appears at the server
startup (during POST), press the [F2] key.
2. Check/change the settings.
3. Select "Save Changes & Exit" from the
Exit menu and press the [Enter] key.
4
Turn the server power off.
For the use of Linux distribution with this server, refer to
Fujitsu PRIMERGY website (http://primergy.fujitsu.com).
2
Insert the ServerStart floppy disk sup-
plied with the server. Click [Continue].
ServerStart initialization process starts. After
completion, the license agreement window ap-
pears.
4