Fujitsu Primergy RX100 S5 Başlangıç Kılavuzu - Sayfa 6

Sunucu Fujitsu Primergy RX100 S5 için çevrimiçi göz atın veya pdf Başlangıç Kılavuzu indirin. Fujitsu Primergy RX100 S5 9 sayfaları.

Sayfayı Yazdır

Turning off the power and installing optional devices

Install optional devices to be installed after the OS installation, such as UPS device.

��

"Chapter 6 Installing Internal Options"

Check that no media is inserted in the

CD/DVD drive, etc.

Exit the OS.

After the OS is exited, the server is automatically

turned off. When the power of the server is not off

after the OS is exited, press the power switch on

the front of the server.

Turn off the power supply of the pe-

ripheral devices, such as the display.

Install the optional devices.

Hints for error handling

In preparation of a failure occurring, set the following:

��

"Chapter 4 Operations after OS Installation"

- Set to collect memory dump

If the memory dump is set, debugging information is automatically saved when the STOP error (blue screen) or hang-up occurs

in the system.

This helps to analyze the cause of error occurrence.

- Create a system restoration disk

When the system file or system environments are damaged, the system can be reconstructed with the content saved in the sys-

tem restoration disk.

- Store system settings

Store the BIOS setting information. By storing the BIOS setting information, the original information can be recovered with the

stored information in case that the setting information is lost. The stored information is used for the system maintenance.

When the settings are completed, make sure to check notes before operation.

��

"4.5 Notes before Operating the Server"

For details about maintenance after operations have started, refer to "User's Guide Chapter 8 Operation and Maintenance".

Support and Service

PRIMERGY information

For the latest information on PRIMERGY, update modules, drivers and the software, refer to the Fujitsu PRIMERGY web-

site.

http://www.fujitsu.com/global/services/computing/server/ia/driver/

Regarding BIOS and firmware, contact to Fujitsu Support Office. Refer to the following website.

http://www.fujitsu.com/global/contact/computing/PRMRGY_index.html

- After optional devices are installed, set the BIOS Setup

Utility as required.

For details about setting procedures, refer to the "User's

Guide Chapter 7 Configuring Hardware and Utilities".

- If a UPS is installed, set the BIOS Setup Utility as re-

quired. For setup procedures, refer to "User's Guide

4.5.3 Notes on Advanced Uninterruptible Power Supply

(UPS)".

When turning on the server again after turning it off, wait for

at least ten seconds and then press the power switch.

If the server is turned on straight after being turned off, an

error will occur that may cause damage.