Fujitsu fi-4220C2 Başlarken - Sayfa 11

Tarayıcı Fujitsu fi-4220C2 için çevrimiçi göz atın veya pdf Başlarken indirin. Fujitsu fi-4220C2 30 sayfaları. Flatbed scanner
Ayrıca Fujitsu fi-4220C2 için: Kurulum Prosedürleri Kılavuzu (7 sayfalar), Kurulum Prosedürleri Kılavuzu (9 sayfalar), Broşür ve Teknik Özellikler (2 sayfalar), Kurulum Prosedürleri (3 sayfalar), Temizlik Talimatları (2 sayfalar)

Sayfayı Yazdır
Fujitsu fi-4220C2 Başlarken

1.3 Operator Panel

The operator panel is located on the right side of the
scanner. This panel comprises of a Function Number
display, four buttons and a LED.
Name
Function Number dis-
play
But-
Function
tons
Send to
Scan
Power button
LED
-
*) About the settings on the launcher, refer to FUJITSU
TWAIN32 scanner driver help and the "fi-4220C2 Opera-
tor's Guide" in the Setup CD-ROM.
Function No.
display
Function
Send to
Scan
Power button
LED
Function
Indicates the function
Number and error status.
Changes the Function
activated by the Send to
button (*).
Launches the linked appli-
cation software (*).
Turns the scanner ON and
OFF.
Lights when the scanner is
turned ON.
fi-4220C2 Image Scanner Getting Started
■ Indications on the Function Num-
ber Display
■ 8
Blinks only one time upon turning on the scan-
ner.
■ P
Indicates that the scanner has been turned ON
and is being initialized.
■ 0
Indicates that initialization will soon end.
■ 1
Indicates that initialization has ended success-
fully.
The scanner is now in "Ready Status".
■ U
Indicates that a temporary error occurred when
documents were being scanned. A number
appearing in alternation following the U (i.e.,
1 or 2, etc.) refers to the type of error.
To return the scanner to the ready status ("1"),
press "Scan" or "Send to" button.
■ E
Indicates that a device (hardware) alarm has
occurred during scanning of documents.
"E" and the alarm Number (2 to 9, c and d)
will appear alternately.
To return the scanner to the ready status ("1"),
press "Scan" or "Send to" button.
If this alarm occurs, turn the power off and on
again. If the alarm continues after turning the
power on again, contact your service engineer.
2