Fujitsu ScanSnap iScanner fi-6010N Başlangıç Kılavuzu - Sayfa 19

Tarayıcı Fujitsu ScanSnap iScanner fi-6010N için çevrimiçi göz atın veya pdf Başlangıç Kılavuzu indirin. Fujitsu ScanSnap iScanner fi-6010N 45 sayfaları. Network adf scanner
Ayrıca Fujitsu ScanSnap iScanner fi-6010N için: Teknik Özellikler (2 sayfalar), Başlangıç Kılavuzu (21 sayfalar), Broşür ve Teknik Özellikler (2 sayfalar), Başlangıç Kılavuzu (21 sayfalar), Temizlik Talimatları (2 sayfalar), Temizlik Talimatları (2 sayfalar)

Sayfayı Yazdır
Fujitsu ScanSnap iScanner fi-6010N Başlangıç Kılavuzu
4. Press the [OK] button.
The restart confirmation screen appears.
5. Press the [Later] button.
The current scanner name, or changed scanner
name after next restart, is displayed.
If the scanner name is the same as
one already in use, network communi-
HINT
cation problems will occur. In this
case, try the following steps:
1. Disconnect the LAN cable, press
the [Shutdown] button on the
LCD touch panel, and turn the
scanner off.
2. Reboot the scanner with the
LAN cable disconnected, and
enter a non-duplicate scanner
name.
3. Reboot the scanner again.
4. Re-connect the LAN cable to the
scanner.
Restart may be performed after all necessary settings
have been completed.
Continue with the Region/Timezone settings.

3.4 Setting the Region/Timezone

1. Select the [System Settings] tab on the top menu.
2. Select the [Region/Timezone] tab on the left
side menu.
The "Region/Timezone" screen appears.
3. Press the [List] button for the "Timezone" input
field.
The default timezone is "(GMT+09:00) Osaka,
Sapporo, Tokyo".
A list of timezones appears.
4. Select a timezone.
5. Select whether "Daylight Savings Time" should
be on or off.
This option is not shown for timezones where
daylight savings time is not used.
6. Press the [OK] button.
The Region/Timezone is set.
Continue with IP address/DHCP settings.

3.5 Setting the IP Address/DHCP

An IP address must be set in order to connect the scan-
ner to a network.
Do not use an IP address that
ATTENTION
already exists in the network.
IP address duplication will cause
an error during setup.
1. Select the [Network Settings] tab on the top
menu.
2. Select the [IP Address] tab on the left side
menu.
The IP address/DHCP screen appears.
8