- ページ 19
スキャナー Fujitsu ScanSnap iScanner fi-6010NのPDF スタートマニュアルをオンラインで閲覧またはダウンロードできます。Fujitsu ScanSnap iScanner fi-6010N 45 ページ。 Network adf scanner
Fujitsu ScanSnap iScanner fi-6010N にも： 仕様 (2 ページ), スタートマニュアル (21 ページ), パンフレット＆スペック (2 ページ), スタートマニュアル (21 ページ), 洗浄方法 (2 ページ), 洗浄方法 (2 ページ)
ページを印刷する
4. Press the [OK] button.
The restart confirmation screen appears.
5. Press the [Later] button.
The current scanner name, or changed scanner
name after next restart, is displayed.
If the scanner name is the same as
one already in use, network communi-
HINT
cation problems will occur. In this
case, try the following steps:
1. Disconnect the LAN cable, press
the [Shutdown] button on the
LCD touch panel, and turn the
scanner off.
2. Reboot the scanner with the
LAN cable disconnected, and
enter a non-duplicate scanner
name.
3. Reboot the scanner again.
4. Re-connect the LAN cable to the
scanner.
Restart may be performed after all necessary settings
have been completed.
Continue with the Region/Timezone settings.
3.4 Setting the Region/Timezone
1. Select the [System Settings] tab on the top menu.
2. Select the [Region/Timezone] tab on the left
side menu.
The "Region/Timezone" screen appears.
3. Press the [List] button for the "Timezone" input
field.
The default timezone is "(GMT+09:00) Osaka,
Sapporo, Tokyo".
A list of timezones appears.
4. Select a timezone.
5. Select whether "Daylight Savings Time" should
be on or off.
This option is not shown for timezones where
daylight savings time is not used.
6. Press the [OK] button.
The Region/Timezone is set.
Continue with IP address/DHCP settings.
3.5 Setting the IP Address/DHCP
An IP address must be set in order to connect the scan-
ner to a network.
Do not use an IP address that
ATTENTION
already exists in the network.
IP address duplication will cause
an error during setup.
1. Select the [Network Settings] tab on the top
menu.
2. Select the [IP Address] tab on the left side
menu.
The IP address/DHCP screen appears.
8