Fujitsu ScanSnap iScanner fi-6010N Başlangıç Kılavuzu - Sayfa 22

Tarayıcı Fujitsu ScanSnap iScanner fi-6010N için çevrimiçi göz atın veya pdf Başlangıç Kılavuzu indirin. Fujitsu ScanSnap iScanner fi-6010N 45 sayfaları. Network adf scanner
Ayrıca Fujitsu ScanSnap iScanner fi-6010N için: Teknik Özellikler (2 sayfalar), Başlangıç Kılavuzu (21 sayfalar), Broşür ve Teknik Özellikler (2 sayfalar), Başlangıç Kılavuzu (21 sayfalar), Temizlik Talimatları (2 sayfalar), Temizlik Talimatları (2 sayfalar)

4. Enter the following numerical addresses:

Primary WINS

Secondary WINS

If a WINS server setting is not required, enter

"0.0.0.0".

A Secondary WINS cannot be set

without a Primary WINS.

ATTENTION

5. Press the [OK] button.

The information entered is set.

Next, check the network connection.

3.9 Checking the Network

Connection

The network connection may be checked by performing

a ping test.

1. Select the [Network Settings] tab on the top

menu.

2. Press the [

] button on the left side menu.

Scroll the left side menu down until the [Ping]

tab appears.

3. Select the [Ping] tab on the left side menu.

The "Ping" screen appears.

4. Enter the IP address, host name, or FQDN for

the server to be used to check the network

connection.

For an IP address

The following format should be used

xxx.xxx.xxx.xxx (xxx is a value from 0 to 255).

For a host name or FQDN

Up to 255 characters may be used.

5. Press the [Ping] button.

A ping test is performed and the results are

displayed. If the result shows "Lost=0 (0%

loss)", the network connection is functioning

normally. For any other result, refer to

"Checking Basic Network Operation with a

Ping Test" (page 24).

After performing all settings, restart the system.

1. Press the [Logout] button.

The restart confirmation screen appears.

2. Press the [Restart] button.

The scanner restarts, and the "Login" screen

appears.

Next, install the Admin Tool.