Fujitsu ScanSnap S1300 Başlangıç Kılavuzu - Sayfa 5
Tarayıcı Fujitsu ScanSnap S1300 için çevrimiçi göz atın veya pdf Başlangıç Kılavuzu indirin. Fujitsu ScanSnap S1300 9 sayfaları. Color image scanner
Ayrıca Fujitsu ScanSnap S1300 için: Broşür ve Teknik Özellikler (2 sayfalar), Başlangıç Kılavuzu (8 sayfalar), Teknik Özellikler (3 sayfalar), Güvenlik Önlemleri (9 sayfalar)
Sayfayı Yazdır
Connecting the ScanSnap
Only one ScanSnap can be used by a
computer at a time.
Use only the cable supplied with the ScanSnap.
CAUTION
Do not use AC adapters other than the one
supplied with this ScanSnap. Doing so may cause
damage to the ScanSnap.
Manufacturer: LEI
Model No.: NU13-1072166-I3
1.
Select the power cable type according to
power source for the ScanSnap.
To use the ScanSnap at a fixed location
Use the power cable to connect to an AC outlet.
For details about the connection, refer to "Using
the Power Cable" (page 5) in Step 3.
AC
Adapter
To use the ScanSnap in a remote location with
your laptop computer or a place without AC
outlets available nearby
Use the USB bus power cable for power supply
from your computer.
For details about the connection, refer to "Using the
USB Bus Power Cable" (page 5) in Step 3.
2.
Remove the tape seal covering the USB
connector and power connector of the
ScanSnap.
3.
1. Connect the power cable
2. Connect the USB cable
AC Cable
USB Bus
1. Connect the USB bus power cable
Power Cable
2. Connect the USB cable
5
Connect cables to the ScanSnap.
To power on the ScanSnap, the USB
cable and either of the power cables
(power cable or USB bus power cable)
need to be connected.
When connecting to USB hub, make sure
to connect the ScanSnap to the USB hub
which is connected to a USB port of your
computer. Use a powered USB hub (with
AC adapter).
If USB port or USB hub is USB 1.1,
scanning speed will slow down.
Connect the USB cable with the USB
mark facing up.
Using the Power Cable
connector of the ScanSnap and plug in the
AC outlet.
connector on the ScanSnap and the USB
port on your computer.
Using the USB Bus Power Cable
power connector on the ScanSnap and the
USB port on your computer.
connector on the ScanSnap and the USB
port on your computer.
to the power
to the USB
to the
to the USB